May 27, 2014 · Using the heavier BB causes the BB to curve down slightly. A slight upward hop-up adjustment made it shoot straight onto the red dot. Jake Tue, ...
At the bottom of the hop-up, BB pellets is fed through the opening into the main hop-up chamber. The lowest gear, out of the three, is accessible from ...
Some times the BB curves down. Some times it curves right. Some times it curves up. Some times it curves left. And some times it hits right on the spot. How ...
The clicking noise means the battery is turning the motor; as the motor turns, the pinion gear on the motor hits the next gear, making the clicking sound. But ...
I have determined that the method documented in this article is a bad idea. See the "Aftermath" section below for details. The better solutions are the Bravo ...
The BB would drop to the ground at 50 feet. We would slide the hop-up back and forth a few times. The we would set it to the lowest setting. All of a sudden ...
It's possible that your motor pinion gear has jammed in the gearbox. By removing the motor, you could have reset the lockup already. Try putting the motor and ...
It has a stock plastic H-hop spacer. The adjustment is accomplished with 0.2g BB's. We will replace the inner barrels without touching the hop-up adjustment, ...
Due to the higher mass, the same hop-up setting causes the 0.25g BB to drop earlier than 0.2g BBs. ... Title: Airsoft Troubleshooting #5: BB Curves Up When Hop-Up ...
