×
To take the receiver apart, you'll have to remove the screw just behind the magazine release catch. And then remove the screw toward the back of the receiver, ...
Next, you'll have to disassembly the magazine release. Flip the receiver to the other side. Use a precision screwdriver to unscrew the magazine release button.
If you don't want your writing to be edited mercilessly, then don't submit it to the MyInk Wiki. Consider, instead, to submit it the Airsoft SpecOps Forums, ...
The photo above shows the MP5 collapsible shoulder stock. The only thing holding it onto the receiver is a pin. The pin is held in place by the flat-screw next ...
There is a hex screw at the bottom of the magazine (see photo below). I used a T9 precision Torx screwdriver to unscrew it. Once you have unscrew the bottom ...
Once you unscrew the Phillips screw, you can slide the bottom plate off the magazine. Then you can push the magazine insert upward and remove it from the top ...
To disassemble the MP5 airsoft high-cap magazine, you have to tap out the pin at the top of the magazine (see photo below). To tap it out, you'll need a punch ...
Once you unscrew the Phillips screw, you can slide the bottom plate off the magazine. Then you can push the magazine insert upward and remove it from the top of ...
The notched hole is used by the hop-up component to provide a spin and changes the speed of the pellet. The side notches are intended to keep the barrel in ...