Google
×
Once you unscrew the Phillips screw, you can slide the bottom plate off the magazine. Then you can push the magazine insert upward and remove it from the top ...
A Phillips screw (see photo below) on the bottom of the magazine, close to the winding wheel, allows you to take it apart.
Next, you'll have to disassembly the magazine release. Flip the receiver to the other side. Use a precision screwdriver to unscrew the magazine release button.
There is a hex screw at the bottom of the magazine (see photo below). I used a T9 precision Torx screwdriver to unscrew it. Once you have unscrew the bottom ...
The next step is to remove the charging handle. It is fastened by a machine screw to the hop-up unit (see photo below). Remove that screw and use the charging ...
Instructions to take the JG UA-3 RAS apart is located here: "How To Disassemble an AUG Airsoft Rifle". ... The magazine is a standard high-capacity AUG airsoft ...
The notched hole is used by the hop-up component to provide a spin and changes the speed of the pellet. The side notches are intended to keep the barrel in ...
To disassemble the MP5 airsoft high-cap magazine, you have to tap out the pin at the top of the magazine (see photo below). To tap it out, you'll need a punch ...
The front iron sight is screwed down with two screws. The bottom one is a machine screw. So when you put them back, be sure they go to the right place. After ...