Prevent Your Airsoft Gun from Losing Spring Tension Weblog: GearHack. Excerpt: One of the biggest problems with FPS drop in airsoft guns is spring tension.

Ball bearings allow the spring to rotate freely, while being compressed to relieve spring's rotational tension while maximizing the linear tension.

Same as previously, the motor gear hits the next gear, but there is not enough power to pull the stronger spring back. There are a lot of solutions in this case ...

Place the safety pin loop onto the spring post, then wedge the leg in between the trigger and contact switch. The photo below shows the correct installation.

The handgrip needs to have a fluorescent, two centimeter wide adhesive band (not intended for removal) around the circumference. The photo below shows what an ...

Jul 20, 2013 · All you have to do to disable the EBB is to unscrew one screw that the EBB plate slide on. See the black screw in the photo below. Attached ...

The best scenario is to have two guns with two sights. When one protector is smashed, switch to the second gun. Two: Carry Aim Sports Lens Protector (see " ...

May 27, 2014 · Using the heavier BB causes the BB to curve down slightly. A slight upward hop-up adjustment made it shoot straight onto the red dot. Jake Tue, ...

If the main spring isn't removed, use a screwdriver to keep the spring guide in place as you separate the gearbox. But if you have a quick change spring system ...

Just make sure the 90 degree adapter clears the gun. Some 90 degree Picatinny rail adapters allows you to screw addition rails to the top. That gives you ...